. | . |
Price Of Processing Ultra Clean Coal Gets Economical
Swindon, UK (SPX) Mar 14, 2006 A new chemical process for removing unwanted minerals from coal could lead to reductions in carbon dioxide emissions from coal-fired power stations. There is already a way of burning coal in a cleaner, more efficient fashion that would reduce carbon dioxide emissions: this is where the coal is turned into a gas and used to drive a turbine. However, problems with cleaning the coal before it is burnt have made generating electricity in this way very expensive. This new chemical process could make it more commercially viable. Under development by a University of Nottingham team with EPSRC funding, the new approach involves using chemicals to dissolve unwanted minerals in the coal and then regenerating the chemicals again for re-use. This avoids the expense of using fresh chemicals each time, as well as the need to dispose of them, which can have an environmental impact. By removing unwanted minerals before the coal enters the power plant the new process helps protect the turbines from corrosive particles. The aim is to cut unwanted minerals in coal from around 10% to below 0.05%, making the coal 'ultra clean'. Removing these minerals before using the coal to generate power prevents the formation of harmful particles during electricity production. To do this, the team is using specific chemicals to react with the minerals to form soluble products which can be separated from the coal by filtration. This process is known as 'leaching'. Hydrofluoric acid is the main chemical being tested. The chemicals not only dissolve the minerals but are also easy to regenerate from the reaction products, so they are constantly recycled. It is this aspect that has largely been overlooked in past research, but is virtually essential if chemical coal-cleaning is to be environmentally and commercially viable. Dr Karen Steel of the School of Chemical, Environmental and Mining Engineering is leading the project. "A lot of research took place in the 1970s and 1980s to see if coal-cleaning was viable," she says. "The conclusion was that it was too expensive. With the environment high on the global agenda and coal certain to remain a key energy source for decades, it makes sense to see if the perception is still justified today." If it proves technically viable and economically competitive, the new process could help ensure that world coal reserves are harnessed with less impact on climate change. ### (As part of National Science Week, EPSRC - the Engineering and Physical Sciences Research Council - is highlighting pioneering energy research to assist global efforts to combat climate change.) Notes for Editors The new process could also help ensure commercial take-up of high-efficiency "combined cycle" power technologies, which have potential to deliver significant carbon dioxide reductions. A combined cycle uses both gas and steam turbines to produce electricity, with the waste heat from the gas turbines used to heat the steam turbines. By increasing generating efficiency, this reduces both the amount of fuel required and the emissions produced per unit of electricity generated. In combined cycles where coal is gasified ('coal gasification'), mineral matter in mined coal gives rise to corrosive particles in the gas, causing severe damage to the turbine that generates electricity. There are two ways of protecting the turbine � removing the particles from the gas before it reaches the turbine, or removing unwanted minerals before the coal enters the power plant. The new process focuses on the second option. Coal gasification involves the use of steam to turn coal into the gases carbon monoxide and hydrogen. These are then combusted in a gas turbine, offering efficiency gains that reduce the amount of carbon dioxide produced by 30-50%, compared with conventional coal combustion. National Science Week, which runs from 10th-19th March and is co-ordinated by the BA (the British Association for the Advancement of Science), celebrates science and its importance to people's lives. Held every year, it provides an opportunity for people of all ages across the UK to take part in science, engineering and technology activities. "Energy and Climate Change" has been selected as a key theme of this year's event. For more information visit: http://www.the-ba.net/Events/NationalScienceWeek/ The University of Nottingham research project "Development of a Process for Production of Ultra-Clean Coal" began in June 2005 and will run until October 2007. It is receiving EPSRC funding of just over �126,000. This is one of many initiatives worldwide looking into ways of using coal to generate electricity more cleanly. Coal currently meets one-third of the UK's electricity needs and will play a key role in meeting growing global energy demand in the decades ahead. Identifying and deploying effective ways of harnessing it at acceptable environmental and economic cost is an urgent priority for the global energy industry. There are two ways to reduce carbon dioxide emissions from power plants � (i) increase the thermal efficiency of the power generation process and so produce fewer carbon dioxide emissions per unit of electricity generated, and (ii) capture the carbon dioxide for long-term storage in secure geological structures. Both are necessary for fighting climate change. At present, natural gas is the preferred fossil fuel for UK electricity generation as it gives a high thermal efficiency on combustion. However, gas resources are becoming scarcer than coal, so efforts are now focusing on increasing the thermal efficiency of coal-fired power stations to match the thermal efficiency of natural gas-fired power stations. Carbon dioxide has been identified as the main gas contributing to climate change. Climate change is now accepted as a fact by an overwhelming majority of the global scientific community. Potential uses for ultra-clean coal, apart from power generation, include production of heavy fuel oil, graphite and carbon fibres. Dr Steel's research has further benefits. As the chemicals are being regenerated, valuable additional products are made, e.g. pure silica � a raw material used in the manufacture of a huge range of products such as silicon chips and solar cells. The ultra-clean coal itself also has non-fuel uses. As a raw material for manufacturing high purity carbon-based products, e.g. electrodes for the aluminium industry, it could act as a substitute for oil. Related Links Engineering and Physical Sciences Research Council Combination Of Processes Results In Cleaner Petrol Delft, The Netherlands (SPX) Mar 10, 2006 One problem confronting the oil industry is that extracted mineral oil (due to increasing scarcity) is becoming heavier and 'dirtier'. This is reflected, for instance, in a higher content of aromatics (which among other things lead to soot emissions during combustion in diesel engines) and of sulphur (which among things causes acid rain). |
|
The content herein, unless otherwise known to be public domain, are Copyright 1995-2006 - SpaceDaily.AFP and UPI Wire Stories are copyright Agence France-Presse and United Press International. ESA PortalReports are copyright European Space Agency. All NASA sourced material is public domain. Additionalcopyrights may apply in whole or part to other bona fide parties. Advertising does not imply endorsement,agreement or approval of any opinions, statements or information provided by SpaceDaily on any Web page published or hosted by SpaceDaily. Privacy Statement |